PCB components and there function! By Imran

In its simplest form, a PCB is a plastic board reinforced with glass. Attached to this board are copper lines and pads which connect together, cut from a copper layer. These copper lines (known as traces) allow electrical charge to flow through the PCB, providing power to the different components that are situated systematically on the board. The copper traces function in the place of wires, guiding the electricity to the correct destination.

The Layers of a The simplest PCBs are single sided boards (one copper layer). However, the copper traces can also be installed on both sides of the board, creating a double sided PCB. They become more and more complex as additional layers are added to the original design. These new layers have their own copper trace formations. The copper connections cannot cross one another without the path of the electrical charge being compromised, so multi layered PCBs become necessary for advanced electronics. However, in the single sided boards one side is reserved for the copper trace and the other side houses the components. On top of the copper layer sits the solder mask and the silkscreen. The solder mask is what makes the PCB its recognisable green colour. This has the function of insulating the copper from any metal parts that might accidently come into contact with it. However, parts of the metal will remain exposed so that they can be soldered to. The silkscreen sits on top of the solder mask again. This has letters and numbers drawn on it which make the assembly of the PCB easier for the engineer (or the hobbyist!). The Components circuit board If the copper traces behave like the skeleton of the PCB, acting as its basic structure – then the components are the vital organs. Each one has a different function. They give the circuit the unique qualities that make it fit for its intended purpose. Depending on the device or electronic item a PCB is designed for, different components will be needed for different circuits. These components can consist of a wide range of electronic parts. Some common PCB components include: Battery: provides the voltage to the circuit. Resistors: control the electric current as it passes through them. They’re colour coded to determine their value. LEDs: light emitting diode. Lights up when current flows through it, and will only allow current to flow in one direction. Transistor: amplifies charge. Capacitators: these are components which can harbour electrical charge. Inductor: stores charge and stops and change in current. Diode: allows current to pass in one direction only, blocking the other. Switches: can either allow current or block depending if they are closed or open.